Portable Button Snap Tester

News of the Day

T85 Lighting

T85 Energy Saving Fluorescent Lamp

Convert traditional T8 fluorescent lamp to T5 energy saving fluorescent lamp, instantly save half of electricity consumption.

Save money,
Environment Protection,
DIY, easy to change, complete in 1 min.
Save labor cost, no need to hire electrican
12000 hours life time
2 years warranty for fixture and 1 year for fluorescent tube

Online Shopping

Lighting Pantone Color Color Assessment Cabinet Ironing and Finishing Cutting Accessories

List All Products
Product Search Advanced Search
Show Cart
Your Cart is currently empty.

Currency Selector

Members Online

None

Home

Testing

Button Tester

Portable Button Snap Tester

Testing Equipment - Button Test

Button & Snap Test Kit -- Portable Type

The measurement of stress, stain and the breaking strength of button/snap fasteners are important factors especially in the design of garments. The reason for the test is due to quality and safety regulations.

Significance & Use:

Quality Control in the garment, thus preventing lose buttons in final products from entering the market. It provides the basis for the most simplified test unit which utilizes a "IMADA" Push/Pull Scale in conjunction to three Grips device.

Mainly Consisting of:

i) IMADA Pull/Push Scale Model FB-30K: Capacity : 0 - 30 kg, resolution 250g. Display the reading of pulling force & record the breaking force		ii) Three Pronged Grip: Application: Plastic Buttons / Snaps. Advantage : design for Snaps Clamping.
iii) Vise Grip: Application : Metal Buttons / Rivets / Tassels / Pompoms / Trims		iv) Table Vise Clamp: Application : Hold the garment or tested sample onto table.

Optional: (i) IMADA Pull/Push Scale Model FB-50LB: Capacity : 0 - 50 LB, resolution 0.5 LB. Display the reading of pulling force & record the breaking force.

Procedures:
Non Destructive Button Tension Test
Fix the Table Vise Clamp (iv) onto a table and adjust it to fix the testing sample. Choose on of suitable Grip (ii, & iii) according to your testing purpose. Adjust the mouth of clamp to grip the testing button/snap/trims. Install the hook onto the Pull direction of Imada Push/Pull Scale and set the zero reading by turning with zero tare ring. Hand Held the Imada Push/Pull Scale and applies the force and a short period of time until the testing requirement. (eg., CPSC requirement apply 15LB (=6.8kg) within 10 seconds). If the testing button/Snap/Trims are not detached from samples, it should be recorded as PASS. Otherwise, it should be recorded as FAIL. Repeat above procedure with other new testing sample.